Before the biogas generator set is put into normal use, it shall be debugged to ensure the normal operation of the unit and reduce the occurrence of unit failure. The following describes the test and detection methods and precautions of full power biogas generator set of China's biogas generator set manufacturers.

　　沼氣發電機組制造商

　　Biogas generator set manufacturer

　　1.檢查沼氣發電機組外觀是否清潔;如果地腳螺母、飛輪螺釘?shù)冗\動部件的螺母有松動跡象，本發明要求在有松動跡象時實時緊固。

　　1. Check whether the appearance of biogas generator set is clean; if the nuts of moving parts such as foundation nuts and flywheel screws show signs of loosening, the invention requires to tighten them in real time when there are signs of loosening.

　　2.沼氣發電機組各缸減壓狀態下,遷移改變曲軸檢查各缸聲音作品相同的戒指,曲軸的遷移轉變,與此同時,油泵進入摩擦表面,然后打開救援機構,搖動曲軸,raid生成器可以氣缸漏氣,如果搖動曲軸時,覺得很困難,并示意緊縮是正常的。

　　2. When each cylinder of the biogas generator set is under pressure reduction, the crankshaft shall be moved and changed. Check the ring with the same sound works of each cylinder. At the same time, the oil pump enters the friction surface, then open the rescue mechanism, shake the crankshaft, and the raid generator can leak air in the cylinder. If it is difficult to shake the crankshaft, and indicate that tightening is normal.

　　3.檢查沼氣發電機組的局部間隙是否準確，尤其要仔細檢查各進、排氣閥的間隙。

　　3. Check whether the local clearance of biogas generator set is accurate, especially the clearance of each inlet and exhaust valve.

　　4.檢查沼氣發電機組燃料供應系統情況，步驟如下:

　　4. Check the fuel supply system of biogas generator set, the steps are as follows:

　　1)檢查沼氣發電機組燃料箱蓋上的通風孔是否暢通，如有污物進入孔內，應及時清洗。參與柴油可以滿足商標的要求，油量可以豐富，并打開油路開關。

　　1) Check whether the vent hole on the fuel tank cover of the biogas generator set is unblocked. If there is dirt entering the vent hole, clean it in time. Participating in the diesel can meet the requirements of the trademark, the fuel quantity can be rich, and the oil circuit switch can be turned on.

　　2)翻轉沼氣發電機組的泄壓機構，轉動曲軸，各缸應有響亮的注油聲，說明注油良好。如果沒有聽到注油的聲音，可能是由于沼氣發生器油回路中的大氣引起的。此時可松開柴油濾清器排氣螺桿及噴射泵，清理油路內的大氣。

　　2) Turn over the pressure relief mechanism of the biogas generator set, rotate the crankshaft, and each cylinder shall have a loud oil injection sound, indicating that the oil injection is good. If no oil filling sound is heard, it may be caused by the atmosphere in the oil circuit of biogas generator. At this time, loosen the diesel filter exhaust screw and injection pump to clean the air in the oil circuit.

　　3)檢查油管是否有漏油跡象，并及時處理。

　　3) Check the oil pipe for signs of oil leakage, and deal with it in time.

　　以上是沼氣發電機組制造商全力公司向用戶介紹的沼氣發電機組出廠前的檢測方法，希望以上的介紹能給用戶提供參考。

　　The above is the test method of biogas generator set before leaving factory introduced by the manufacturer of biogas generator set to the user. I hope the above introduction can provide reference for the user.